Roland XP-60 Manual Del Usuario página 199

Hold 2 (Controller number 69)
status 2nd byte 3rd byte
BnH 45H vvH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 7FH (0 - 127)
Sound Controller 2 (Controller number 71)
status 2nd byte 3rd byte
BnH 47H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-128 - 0 - +126)
Sound Controller 3 (Controller number 72)
status 2nd byte 3rd byte
BnH 48H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-128 - 0 - +126)
Sound Controller 4 (Controller number 73)
status 2nd byte 3rd byte
BnH 49H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-128 - 0 - +126)
Sound Controller 5 (Controller number 74)
status 2nd byte 3rd byte
BnH 4AH kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-64 - 0 - +63)
General Purpose Controller 5 (Controller number 80)
status 2nd byte 3rd byte
BnH 50H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-128 - 0 - +126)
General Purpose Controller 6 (Controller number 81)
status 2nd byte 3rd byte
BnH 51H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-128 - 0 - +126)
General Purpose Controller 7 (Controller number 82)
status 2nd byte 3rd byte
BnH 52H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-128 - 0 - +126)
General Purpose Controller 8 (Controller number 83)
status 2nd byte 3rd byte
BnH 53H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-128 - 0 - +126)
Portamento control (Controller number 84)
status 2nd byte 3rd byte
BnH 54H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
kk=source note number : 00H - 7FH (0 - 127)
Effect 1 (Reverb Send Level) (Controller number 91)
status 2nd byte 3rd byte
BnH 5BH vvH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=Reverb Send Level : 00H - 7FH (0 - 127)
Effect 3 (Chorus Send Level) (Controller number 93)
status 2nd byte 3rd byte
BnH 5DH vvH
n=MIDI channel : 0H - FH (ch.1 - ch.16)
vv=Chorus Send Level : 00H - 7FH (0 - 127)
Program Change
status 2nd byte
CnH ppH
n=MIDI channel : 0H - FH (ch.1 - ch.16)
pp=Program number : 00H - 7FH (prog.1 - prog.128)
* This message is not transmitted when the Tx Program Change parameter
(SYSTEM/MIDI/MIDI Param 2) is OFF.
Capítulo 12. Material suplementario
Channel Aftertouch
status 2nd byte
DnH vvH
n=MIDI channel : 0H - FH (ch.1 - ch.16)
vv=Channel Aftertouch : 00H - 7FH (1 - 128)
Pitch Bend Change
status 2nd byte 3rd byte
EnH llH mmH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
mm,ll=Pitch Bend value : 00 00H - 40 00H - 7F 7FH (-8192 - 0 - +8191)
System Realtime messages
Active Sensing
status
FEH
* Transmitted at intervals of approximately 250ms.
* Not transmitted if the Tx Active Sensing parameter (SYSTEM/MIDI/MIDI
Param 2) is OFF.
System Exclusive messages
Data Set1 DT1
status data byte
F0H 41H, dev, 6AH, 12H, aaH, bbH, ccH, ddH, eeH, ... ffH, sum
Byte Remarks
F0H Exclusive status
41H ID number (Roland)
dev device ID (dev: 10H - 1FH)
6AH model ID (XP-60/XP-80)
12H command ID (DT1)
aaH address MSB
bbH address
ccH address
ddH address LSB
eeH data: The actual data to be transmitted. Multi-byte data is trans-
mitted in the address order.
: :
ffH data
sum checksum
F7H EOX (End Of Exclusive)
* The amount of data transmitted at one time is fixed for the type of data, and
the data will be transmitted with the fixed starting address and size. Refer
to the address and size given in "5. Parameter address map" (p.221).
* Large amounts of data must be divided into packets of 128 bytes or less,
and transmitted at intervals of approximately 20 ms.
* For the checksum, refer to p.227.
3. Data reception (Sequencer section)
3.1 Messages recorded during recording
Channel voice messages
Note Off
status 2nd byte 3rd byte
8nH kkH vvH
9nH kkH 00H
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
kk=note number : 00H - 7FH (0 - 127)
vv=Note Off Velocity : 00H - 7FH (0 - 127)
Note On
status 2nd byte 3rd byte
9nH kkH vvH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
kk=note number : 00H - 7FH (0 - 127)
vv=Note On velocity : 01H - 7FH (1 - 127)
Polyphonic Aftertouch
status 2nd byte 3rd byte
AnH kkH vvH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
kk=note number : 00H - 7FH (0 - 127)
vv=Polyphonic Aftertouch : 00H - 7FH (0 - 127)
* This message is not received if the Poly Aft parameter (Rec Select window)
is OFF.
status
F7H
219