Connections; Connecting The Cables; Connecting The Charger; Preliminary Settings - Compex performance Manual Del Usuario

2. Connections

Connecting the cables

T he stimulator cables plug into the
4 sockets on the front of the device.
F our cables can be connected
simultaneously to the four channels of
the device. Both the sockets and the
cables are colour-coded to simplify use
and facilitate identification of the
different channels:
blue = channel 1
yellow = channel 3
The Performance stimulator bears
m-
the label
can use certain functions of the
technology if a stimulation cable
fitted with the
connected. This cable, sold
separately, gives access to the
m-3 m-5
,
functions. It is connected to any one
of the four stimulation channel
sockets located on the front of the
device and two electrodes are
"clipped" on to it in the same way as
for a conventional cable.

Connecting the charger

he Compex has considerable operating
T
autonomy, as it uses rechargeable
batteries.
o recharge them, use the charger
T
supplied with your device and connect it
to the front of the device, then plug the
charger in a socket.
emove any stimulation cables connected
R
to the stimulator before recharging it.
e strongly recommend you fully charge
W
the battery before using it for the first
time as this will improve its autonomy
and life span.
266
green = channel 2
red = channel 4
, in other words it
ready
m-4
system is
m-6
and

3. Preliminary settings

B efore using the unit for the first time,
you should select the working language of
the device which is displayed on the
options screen. Follow the instructions
below. Afterwards, for the greatest
comfort, Compex offers you a number of
setting options (choice of language,
screen contrast adjustment, adjusting
backlighting and sound volume setting).
To change any of these settings, bring up
the options screen by holding the
On/Off button on the left of the
stimulator for a few seconds.
m
1b Use the channel 1 +/- button to choose the
language you wish to use.
1c Use the channel 2 +/- button to adjust the
contrast of the screen.
1d Use the channel 3 +/- button to adjust the
volume.
1e Use the channel 4 +/- button to adjust the
backlighting.
On: backlighting always on.
Off: backlighting always off.
Auto: backlighting activated whenever a button
is pressed.
1a Press the On/Off button to validate the
selected parameters. Your stimulator saves your
options. It is now ready for use with the settings
you selected.