Patch Options; Advanced Controls - Blackmagic Design Cintel Manual De Instalación Y Funcionamiento

Patch Options

These options let you customize the effect of a patch filling over a blemish.
Mute: Lets you turn a particular patch on or off via keyframing. Useful for blemishes that
‚
only show up for a few pixels of a shot.
Variability: (Spatial patches only) Raising this parameter lets you make the fill method
‚
less uniform.
Soft Edges: Lets you soften the edges of the patch.
‚
Size Adjust: Lets you change the size of a patch after its creation.
‚

Advanced Controls

These controls let you customize the UI of this effect.
Clone Sticks to Mouse:
‚
clone or blend clone mode immediately switches to positioning the sample region,
making it faster to use.
New Patches Stay Selected:
‚
them, in preparation for further customization.
UI Line Thickness:
‚
Patches Stick to:
‚
clips that have been stabilized.
– Source: Patches remain in place unless you apply motion stabilization to the shot.
In this case, patches move along with the image so they remain associated with the
feature selected in the source clip.
– Scene: If you're eliminating a blemish on a moving subject, you can use the FX
tracker to track the thing you're fixing, so the patch follows along with it.
Output Mode: This lets you see different representations of the patched effect you're
‚
creating. There are four options.
– Patched Result: The final result, with each patch repairing the blemish it's covering.
– Patch Locations: Shows a key where each placed patch is white against black.
– Differences: Shows the difference of each patch against the original image.
– Difference Magnitude: Shows a more pronounced differences representation.
When enabled, drawing or placing a rect, ellipse, or patch in
When enabled, patches stay selected after you draw
Lets you choose how thick the on-screen outlines should be.
This parameter lets you deal with fixing dead pixels or blemishes on
Dead Pixel Fixer 96