Ambu aView 2 Advance Instrucciones De Uso página 19

Some PACS systems may require the MAC address and the IP address of the displaying unit.
The MAC address is unique for each displaying unit, while the IP address is assigned by the
hospital network.
Retrieve the MAC address and IP address of the displaying unit:
• Login as Administrator, then go to Settings - About - Device Info.
• Depending on whether Wi-Fi or Ethernet is used, find the information tab Network.
The MAC address is a 48-BIT address grouped into 6 octets. In the example below, the MAC
address is highlighted in red boxes depending on the network setup.
The IP address assigned by your network can also be found. In the example below, the IP address
is highlighted in a blue box.
5.2.3. Set up connection to Worklist server:
• Press the ON/OFF slider next to Enable Worklist 31 (switch to green).
• Press the input fields next to Worklist server AE title, Worklist server hostname and
Worklist server port number 32 and enter the required information in each field.
• Press the required setting next to TLS 33 .
Note: If you enable TLS, you need to import the required TLS certificate from a server or USB flash drive
(see instructions further below).
• Press the required modality or enter one in the input field 34 .
• Press the input field next to Display upcoming procedures (hours) 35 and enter the
required number of hours.
• Press arrow right to select Hide past procedures older than (hours) 36 and enter the
required number of hours.
33
37
38
32
34
35
36
31
19