Ambu aView 2 Advance Instrucciones De Uso página 38

Problem
No Live image
from the visualization
device on the
displaying unit
screen
OR
No LED light in the
distal end of the
visualization device.
The Live image on
the displaying unit
screen is only working
while booting.
No image or User
Interface on the
external monitor.
The colours,
contrast, sharpness,
and brightness
look different
on the external
monitor than on
the displaying
unit screen.
The touch interface
does not respond.
38
Possible cause
Failure on visualization
device or visualization
device connection.
The displaying unit
and the Ambu
visualization device
have communication
problems.
Failure on visualization
device connector port.
A recorded image
is shown in the
Procedure Folder tab
OR
A menu box is blocking
the live image.
Processing failure.
The external monitor is
turned OFF.
An issue with cable or
cable connection.
Wrong input channel
is selected on the
external monitor.
SDI – External monitor
does not support 3G-SDI.
Image settings on the
external monitor are
not correct.
The displaying unit has
internal communication
problems.
Recommended action
Connect/reconnect visualization device.
Perform a Power OFF Cycle
(follow the procedure above this table).
Try one of the other visualization device
connector ports.
If an image is obtained from the other
connector port, then the first connector
port may need to be replaced.
If none of the connector ports provide
an image, try again using a new
visualization device.
Return to live image by pressing
the Live View tab
OR
If this does not work, perform a Power
OFF Cycle (follow the procedure above
this table).
Perform a Power OFF Cycle
(follow the procedure above this table).
Turn ON the external monitor.
Check that the SDI or HDMI cable
is connected correctly.
If possible, try a new cable. It is
recommended to use a high-quality cable
with better shielding. (e.g. RG6 grade).
Make sure the correct input channel is
selected on the external monitor.
Make sure that your external monitor
supports 3G-SDI (1920 x 1080 p 60 fps.).
Adjust the image settings on
the external monitor to achieve
the desired result.
Refer to the Instructions for Use for the
external monitor.
Perform a Power OFF Cycle
(follow the procedure above this table).
.