Malaguti SPIDER MAX GT 500 Manual Diagnóstico página 135

SPIDER MAX 500
1.5 Radiator coolant temperature indicator function (WTEMP)
The information is displayed in graphic mode (by a ten-segment bar on the left hand side of the display) and by the
switching on of the radiator coolant indicator (see F. 1). This function is displayed with any function selected or warning
message on. Failure to connect the resistive sensor to the equipment is indicated by the blinking of the led and of the
corresponding icon on the display (f=1Hz, duty=50%). In order to avoid displaying wrong readings, the sensor is read
every 10 sec and the graphic bar is updated 1 segment by one. This means that, in case the sensor resistive value
suddenly shifts from the maximum to the minimum value, it will take 90 seconds to display the 10 segments.
A temperature below 35 °C will be displayed by the partial switching on of the first segment of the graphic bar.
When the 10th segment is displayed, the led and the entire bar start blinking. The graphic bar operation is indicated in the
following table:
Temperature
<35°C
35°C ÷ 45°C
45°C ÷ 55°C
55°C ÷ 70°C
70°C ÷ 80°C
80°C ÷ 90°C
90°C ÷ 105°C
105°C ÷ 110°C
110°C ÷ 115°C
115°C ÷ 119°C
≥120°C
1.6 Fuel level indicator function (FUEL)
The information is displayed in graphic mode (by a ten-segment bar, on the right hand side of the display) and by the
switching on of the fuel icon (see F. 1). This function is displayed with any function selected or warning message on.
Failure to connect the resistive sensor to the equipment is indicated by the blinking of the led and of the corresponding
icon on the display (f=1Hz, duty=50%). The sensor is read every 5 sec and the bar is updated one segment by one. In
order to avoid displaying wrong readings, caused by the fuel fluctuations in the tank, the graphic bar is updated only
when the detected fuel level remains constant during three following readings with respect to the current reading. In case
the sensor resistive value suddenly shifts from the maximum to the minimum value it will take 15sec*10 segments=150
seconds to display the 10 segments.
The 1st segment indicates the fuel reserve and cause the corresponding led to go on.
All manuals and user guides at all-guides.com
No. of segments
1 (partial)
1
2
3
4
5
6
7
8
9
10 + Led
9
Sensor resistive value
> 1650Ω
From 1650Ω to 1000Ω
From 999Ω to 770Ω
From 769Ω to 400Ω
From 399Ω to 301Ω
From 300Ω to 216Ω
From 215Ω to 151Ω
From 150Ω to 130Ω
From 129Ω to 112Ω
From 111Ω to 95Ω
≤
94Ω
12/04
A