Precautions - Malaguti SPIDER MAX GT 500 Manual Diagnóstico

SPIDER MAX 500
2.

PRECAUTIONS

1. Before any intervention on the injection system, check for any anomaly recorded.
Do not disconnect the battery before performing the anomaly check.
2. The fuel supply system pressure is 300 KPa (3 BARS). While disconnecting the quick coupling of the fuel supply
system hose, do not use bare flames and do not smoke. Be careful, the fluid may splash and get in contact with
the eyes.
3. While servicing the electrical components, do not leave the battery connected unless it is strictly necessary.
4. When checking the operation functions, make sure that the battery voltage is above 12V.
5. Before trying to start up the engine, make sure that the tank contains at least 2 litres of fuel. Failure to observe this
precaution may damage the fuel pump.
6. In case the motorcycle is not used for a certain period of time, refill the tank up to half of its capacity so that the
pump is plunged into the fuel.
7. While washing the motorcycle, do not pour water on electrical components and cables.
8. In case of anomalies in the ignition system, first check the battery and the injection system connections.
9. Before disconnecting the EMS central unit connector, carry out the following operations, in the indicated order:
- Position the key switch on the "OFF" position;
- Disconnect the battery;
Failure to observe this instruction may damage the central unit.
10. When reassembling the battery, take care not to invert the poles.
11. In order to avoid any damage, avoid disconnecting and reconnecting the EMS system connectors unless it is
strictly necessary.
Before reconnecting them, check connectors for humidity.
12. While performing electrical checks, do not force the multimeter prods into the connectors. Do not carry out any
measurements not indicated by the Manual.
13. After performing the test by means of the diagnostic multimeter, remember to protect the system connector with
the special cap. Failure to observe this rule may damage the EMS central unit.
14. Before reconnecting the fuel supply quick couplings, check that the terminals are properly cleaned.
All manuals and user guides at all-guides.com
32 03/05
B