Malaguti SPIDER MAX GT 500 Manual Diagnóstico página 199

Tabla de contenido

Publicidad

SPIDER MAX 500
12.10 Pump support revision
In order to remove the pump support from the fuel tank,
proceed as follows:
- Disconnect the electrical connector;
- Start the engine and wait until it stops;
- Clean the tank and the pump support (if necessary, wash
and bleed with compressed air);
- Disconnect the delivery and the return pipes by acting on
the quick couplings.
Try to prevent the fuel to splash.
- Lose the pump support gear nut.
- Remove the pump support and the sealing gasket (A).
NOTE - While extracting the pump support pay attention
not to damage the float arm.
In order to replace the components, proceed as follows:
(1) level indicator:
• Take note of the assembling position and of the path
runned by the two connecting cables.
pos. 2 = cable connected to the circuit
pos. 3 = cable connected to the mobile cable.
All manuals and user guides at all-guides.com
73
F. 33
F. 34
F. 35
F. 36
12/04
B
A

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido