Malaguti SPIDER MAX GT 500 Manual Diagnóstico página 179

SPIDER MAX 500
Correct central unit dashboard
supply
Check the input voltage to the immobilizer: PIN 2 connector, equipment side (yellow/green cable)
- Position the key switch on the "ON" position.
- Position the emergency switch on "RUN".
- Lift the side stand.
F. 14
Check the input voltage to the immobilizer: PIN 3, connector, equipment side (yellow/white cable)
- Position the key switch on the "ON" position.
- Position the emergency switch on "RUN".
- Lift the side stand.
F. 14/a
Find the interruption of the yellow/white cable and repair
it (see electrical diagram).
All manuals and user guides at all-guides.com
Check the following connections:
A) key switch → emergency switch;
B) emergency switch → side stand switch;
C) side stand switch → Immobilizer.
Always refer to the electrical diagram when perfor-
ming the above described checks.
NOTE - The system operation can also be checked by means of:
- signal of engine start-up failure
- starter control operation
Restore the system or replace the faulty component.
53
Release the
connector rubber
dust (A), equipment
side
Extract the
connector rubber
dust (A), equipment
side
Replace the immobilizer.
Store the keys (see
paragraph 18.1 - p. 24).
12/04
B
Battery
voltage
(V=)
Battery
voltage
(V=)