Malaguti SPIDER MAX GT 500 Manual Diagnóstico página 138

SPIDER MAX 500
3.2 Oil Check / Oil Change Alarm
The system is configured to show messages concerning the need for a
check to be performed, as explained in paragraph 1.4.
The routine allows displaying the service icon along with the message OIL
CHANGE or OIL CHECK going on and blinking (f=1 Hz, duty=50%) according
to the type of alarm. The warning message lasts for 1 minute and goes on
only when the key switch is on the "ON" position (F. 8). This algorithm will
stay on until the Dealer who carries out the service operations, as indicated
in paragraph, disables it. 6.4. After showing the message, the previously
selected information will be displayed again.
• While the warning message is on (60 sec.), the button function is disabled.
• While the warning message is on (60 sec.), the only functions that persist on the display are "Fuel"(fuel level indicator),
"wtemp" (radiator coolant temperature) and "hydraulic stand alarm" (when present).
• The alarm is displayed with any function selected.
3.3 V.Belt Change Alarm
The system is configured to show messages concerning the need for a
check, as described in paragraph 1.4.
The routine allows displaying the service icon together with the message
V.BELT CHANGE going on and blinking (f=1 Hz, duty=50%) (F. 9). The
warning message lasts for 1 minute and goes on only when the key switch
is on the "ON" position. This algorithm will stay on until the Dealer who
carries out the service operations, as indicated in paragraph 6.5, disables
it. After showing the message, the information previously selected will be
displayed again.
• While the warning message is on (60 sec.), the button function is disabled.
• While the warning message is on (60 sec.), the only functions that persist on the display are "Fuel" (fuel level indicator),
"wtemp" (radiator coolant temperature) and "hydraulic stand alarm" (when present).
• The alarm is displayed with any function selected.
3.4 Oil pressure indicator alarm (OIL LOW PRESSURE)
Every time that the sensor is closed to ground and Rpm10 is displayed,
the corresponding warning message is shown on the display. The routine
displays the blinking message OIL LOW PRESSURE (f=1 Hz, duty=50%),
and the oil icon (F. 10). In order to avoid displaying false warning messages,
this message appears only when the pressure switch remains closed to
ground for a period of time not below 1.5 ÷ 2.0 seconds. The warning
message will stay on until the sensor signal will be low (= ground), or until
Rpm10 is reached. If the motorcycle engine is not running (Rpm =0), no
warning message is displayed even if the pressure switch is closed to
ground. In order to allow checking the equipment operation, the pressure
switch closing is indicated during the 8 seconds subsequent to the key
switch shift to the "ON" position, no matter whether there is signal on the rev. counter cable. After 8 seconds, the alarm
will be displayed together with the number of rpm.
All manuals and user guides at all-guides.com
12 12/04
F. 8 OIL Service Alarm
F. 9 V.BELT Service Alarm
F. 10 OIL Alarm
A