Publicidad
2
_To
install bagger components to tractor
1. DischargeChute
2. 3/8 Nut
3. Flat Washer
•
Removedischarge chutefrom rearoftractor.Unhookthe
two(2) strapsend pullchute out and away from tractor.
•
Remove the two (2) 318 nuts and flat washersfrom the
boltsat the tractorbackplate.
1. 3/8 Locknut
2. FlatWasher
3. SupportTube
•
Using the nuts and flat washers removedfrom tractor
back plate, installthe bagger supporttube to the back
plate as shown. T ightensecurely.
1.
2.
3.
4.
5.
SupportBracket
4
ClevisPin 10 x 17mm .,,
RetainerSpring
5
_ \
ClevisPin 10 x 50mm
3
10,3mm (13/32") flat
washer
•
Installthe two uppersupportbracketsthroughthe back
plate and to the chassis,installthe clevispin 10x17mm
and secure with retainerspring.
•
Assembleboth supportbracketsto the outside of the
bagggersupporttubeinstallthe clevispin10xS0mmand
securewith retainerspring.
1. Hook
2.
DischargeChute_
3.
Backplateslot
3
•
Replace discharge chute into rear opening of tractor.
Secure the chute withthe two hookstraps.
NOTE; The straphookmustgo through the dischargechute
only. Do not allowthe hook to enter the slot in the tractor
backplate.Thiswillallowthedischargechutetofloat withthe
mowerdeckwhen movingon uneventerrain.
23
Publicidad
