Astoria STORM 4000 SAEP 2GR Manual De Uso Y Mantenimiento página 53

Turning the machine on and off
7.3
After the hydraulic and electrical mains have been
connected by a Qualified Technician, make sure that the
drain tray under the cup holder grille (10) is correctly
connected to the drain.
Check that all the
steam valves are closed.
Turn the machine on
using the main switch (1)
and follow the instruc-
tions provided on the dis-
play, as described below.
When the machine has started up, the warm-up phase
begins. When the warm-up phase has been completed,
the machine will be ready to dispense coffee and the
screen shown below will appear on the display.
USER Manual
10
1
It may sometimes take longer for the steam to be
ready for dispensing than the coffee. If this occurs, wait
a few minutes until the green steam icon appears on
the display.
The green icon indicates that the machine is at the
programmed pressure and steam is ready to be dis-
pensed.
Before using the machine, carry out some empty dispensing cycles
with the filter holders attached for several seconds. This procedure
releases any air inside the hydraulic circuit and in turn, allows the
dispensing groups to fully heat up.
In some cases, such as, for example, after the groups
have been washed, all the selections may be inactive for
a short time, the display may have reduced brightness
and some messages may appear on the right bar.
Simply wait a few seconds until the temperature has
been fully regulated: the display will return to its normal
brightness and all the selections will once again be active.
7.3.1 Turning the machine off
Turn off the machine via the main switch (1).
Steam
not available
Coffee supply
not available
53 260
of