Blodgett SG3240 Serie Manual Del Operario página 18

Installation
Oven Assembly
OPTIONAL FOLDING CONVEYOR
The folding conveyor assembly must be installed
from the electrical box side of the oven.
1. Unfold the right side of the conveyor.
2. Push the conveyor onto the conveyor support
angles.
3. Unfold the left side of the conveyor and con-
tinue to push onto the support angles.
NOTE: Push until the sprocket on the folding
conveyor is inside the electrical box.
See View A.
View A
Sprocket
Locating
Pin
See View A
Conveyor
Bracket
Figure 14
4. Install the drive chain around the drive motor
sprocket and the sprocket on the folding con-
veyor. Pull the folding conveyor to tighten the
chain.
5. Secure the folding conveyor using the con-
veyor locating pin. Install the pin from the in-
side of the electrical box, through the con-
veyor bracket and into the folding conveyor.
See View A.
NOTE: If the mounting hole cannot be lined up or
the chain is too loose, the drive motor will
need to be repositioned.
Folding Conveyor
(shown without belt for clarity)
16
See View A