Start Up / Trial Run; Before First-Time Use; Safety Check; Malfunctions On Start-Up - Hettich BlueMax Mini Modular Instrucciones De Servicio

Start up / trial run

6. Start up / trial run
1. Before first-time use
2. Safety check

3. Malfunctions on start-up

4. Machine versions supplied

1. Machine with article numbers:

9 131 498 and 9 131 499
2. Machine with article number: 9 132 099
5. Optional accessories
6. Interchangeable drilling units
Interchangeable drilling unit, 9 spindles,
Interchangeable drilling unit, 3 spindles, Selekta /
Interchangeable drilling unit, 6 spindles
Interchangeable drilling unit, 9 spindles
Interchangeable drilling unit, 90°, 9 spindles
7. Installing, assembling and connecting
en
8. Assemblies
Press-in frame for the interchangeable drilling unit,
6 spindles
Centre stop
Continuation stops
Drum stops
Hold-down clamp
Converting from manual operation to foot switch
Connection assignment
9. Connecting to extractor system
Connecting to compressed air supply
Connecting to power supply
10. Carrying out trial run
Pushbutton:
Information on trial run
Preliminary conditions
11. Concluding start-up
120

1. Before first-time use

Note!
120 The machine is started up for the first time and
inspected for acceptance by skilled personnel from
120
Paul Hettich GmbH & Co. KG.
120
Before the machine is started for the first time, make sure
the described basic settings and trial runs have been made
121
and the machine is ready for operation.
The following checks must be made before start-up:
121
• check the machine for correct installation and alignment,
121
• check all screw connections at the various stations for
121
secure fit,
121
• check the safety guards for proper working order and
• check the power and compressed air connections for proper
connection and secure fit.
121

2. Safety check

121
Satisfy yourself that:
121
• installation, set-up and servicing work have been
121
completed in full and no persons are present in the danger
122
zone, let alone working on it,
• all safety guards / covers are in place,
122
• the compressed air supply is ready for operation, and
123
• the controls are freely accessible.
124
3. Malfunctions on start-up
127
On start-up, immediately switch OFF the power supply to the
128
machine if:
129
• unusual operating noises can be heard,
130
• the machine runs irregularly, oscillates or vibrates,
130
• tools malfunction,
131
• auxiliary units malfunction
131
• the motors consume too much power
132
• there are electrical faults, and
132
• tools overheat.
132
Danger!
132
Never put this machine into operation if work is still
133
being performed on this machine or on the electrics.
Establish the cause of any malfunction with the machine
shut down and made safe and have it rectified by a
qualified and skilled person trained to do so or eliminate the
malfunction yourself if you are in possession of the necessary
qualification.
Caution!
Only switch the machine back on again once
malfunctions / faults have been properly and
completely rectified!