Hettich BlueMax Mini Modular Instrucciones De Servicio página 150

Operation
Drilling with the continuation stop
(shown here with the right continuation stop)
Push workpiece up against centre stop
hole in the hole line, for 19 mm panel material = 10 mm)
en
Activate drilling process and move panel material to the right
until the pendulum of the continuation stops has slid over
the last drill hole. Now pull the panel material back until the
pendulum pin has engaged in the drill hole and is perfectly
vertical. Pull workpiece as far as the pendulum stop
Restart drilling process and check distance between
last drilling of 1st drilling process and 1st drilling of second
drilling process
7.
150
(start position of 1st
5
5
.
6
6
7