Hettich BlueMax Mini Modular Instrucciones De Servicio página 125

Switch for hold-down clamp / stroke reduction
Set switch for hold-down clamp to hole line
This will automatically release the hold-down clamps after
the drilling process which means there is no need to release
them manually. Swivel in swivelling lever for stroke reduction.
With the motor switched off, move the machine to the drilling
position and move lever inwards (hole line pictogram
can be seen) .
4
Drilling with the continuation stop
(shown here with the right continuation stop)
Push workpiece up against centre stop
hole in the hole line, for 19 mm panel material = 10 mm)
Activate drilling process and move panel material to the right
until the pendulum of the continuation stops has slid over
the last drill hole. Now pull the panel material back until the
pendulum pin has engaged in the drill hole and is perfectly
vertical. Pull workpiece as far as the pendulum stop
.
3
3
4
(start position of 1st
5
5
.
6
6
en
125