Drum Stops - Hettich BlueMax Mini Modular Instrucciones De Servicio

Drum stops

The drum stops are premounted and set.

Drum stops

must be installed on both sides of the machine.
1
1
Precision-adjust using stop pin .
2
Three stops are already pre-set at the following spacings:
a. 22 mm
en
b. 37 mm
c. 57 mm
The fourth stop can be set wherever chosen and must be
installed. A stop screw is provided.
For 9-spindle 90° interchangeable drilling unit, for example, set
the bench 69.5 mm on the scale and tighten the screw against
the bench profile.
This produces a distance of 37 mm from the edge of the bench
top in relation to the interchangeable drilling unit's 1st drilling
spindle.
Loosen bench top at fixing screw to make setting. Position
3
3 2
both stop pins at the required spacing (turned).
2
Now push bench against stop pins and re-fasten.
3
Photograph shows view of right-hand side.
Always follow the assembly instructions!
127