Setting Up (Preparing For Work); Tools Used (Drill Bits) - Hettich BlueMax Mini Modular Instrucciones De Servicio

5. Setting up (preparing for work)

First select the appropriate interchangeable drilling unit.
The machine comes in 4 versions.

Tools used (drill bits).

First install the drill bits required. This setting applies to all
interchangeable drilling units.
Insert required drill bit
1
the two screws using Allen key
7
When fitting, make sure drill bit chucking face
positioned. The screws must clamp the bit in position at this
face.
Pre-mounted drill bits
Push pre-mounted tool
4
drilling unit and turn in opposite direction of drilling-unit
5
rotation.
The bayonet chuck engages.
Repeat this process until all tools are securely engaged.
Always close off unneeded tool holders with a dummy
plug .
6
Always check your work before fitting the interchangeable
drilling unit.
The drill bits must engage and all screws must be tight.
Note!
Pay attention to colour marking.
Drill bits marked red must be used for spindles turning
anticlockwise.
Drill bits marked black must be used for spindles turning
clockwise.
into bayonet chuck and tighten
2
.
3
is correctly
8
into tool holder of interchangeable
4
6
7
8
1
2
3
5
en
135