Continuation Stops - Hettich BlueMax Mini Modular Instrucciones De Servicio

Continuation stops

The continuation stops are premounted on the Interchangeable
drilling unit, 9 spindles.
Setting the continuation stops
Setting height of the continuation stop
The height of the left and right continuation shop must
be adjusted to suit the panel thickness by means of top
setting ring . The continuation stop's finger should engage
1
as deeply as possible into the drill hole. A space of approx. 3 mm
must also be allowed between workpiece and stop
(insert a 3 mm hexagon socket spanner
Switch for hold-down clamp / stroke reduction
Set switch for hold-down clamp to hole line
This will automatically release the hold-down clamps after
the drilling process which means there is no need to release
them manually. Swivel in swivelling lever for stroke reduction.
With the motor switched off, move the machine to the drilling
position and move lever inwards (hole line pictogram can be
seen) .
4
1
)
2
2
.
3
3
4
en
149