Stenner Pumps S Serie Manual De Instalación Y Mantenimiento página 13

GENERAL INFORMATION
PUMP STATUS INDICATORS
PERFORMANCE INDICATORS ACTIVATED BY PUMP STATUS
Pump Status
Tube Change
Tube Leak
Standby
Drive Fault
Off
Run
Mode Change
**
Transfer
Repeat Pulse
High Signal
Low Signal
High Flow
Low Flow
Signal Overrun
* Scalable, invertible
** Transfer operation from a primary pump to a backup pump via a relay.
REMOTE COMMUNICATION CAPABILITY WITH MODBUS RTU over RS-485
Requirements
• S Series Pump with firmware version 3.02.02 or higher
• Applicable modes of operation: Manual, 4-20mA, 010VDC, or Pulse
• Stenner Modbus manual
• Modbus RS-485 communication cable & 1 three terminal, liquid tight junction;
purchased separately, part number MOD100
S Series FW 4.01.02 US and Canada 800.683.2378, International 904.641.1666 www.stenner.com
continued
Pump Status Indicators
Display Alarm Three Output Relays to
on control panel pump, system or device
✓
✓
✓
✓
✓
––––––
––––––
––––––
––––––
✓
✓
✓
✓
✓
Modes of Operation
✓
✓
✓
✓
All Modes of Operation
✓
✓
✓
✓
Manual, 4-20mA
✓
Pulse, 7 Day Timer, Cycle Timer,
PPM Feed: Flow switch
✓
4-20mA
✓
4-20mA
✓
Hall Effect or PPM Feed: Hall Effect
✓
Hall Effect
✓
13
* *
, 0-10VDC ,
* *
or 0-10VDC
* *
or 0-10VDC
Pulse