Stenner Pumps S Serie Manual De Instalación Y Mantenimiento página 93

S30 & S40 TUBE REPLACEMENT
H Place new tube
Cover Feet
I Install cover feet first
Prime Button
J Depress the prime button
Center of Roller Assembly
K Align cover feet near bottom
L Expand roller assembly
M Apply Aquashield ™ to cover bushing
S Series FW 4.01.02 US and Canada 800.683.2378, International 904.641.1666 www.stenner.com
INSTALL THE TUBE/
EXPAND THE ROLLER ASSEMBLY
1. Ensure the power to the pump is off and the input signal is
2. Install the tube.
3. Place the tube housing cover (feet first) on the tube housing, affix the
4. With the cover latched, plug the pump in. Depress the prime
3 Lugs
5. Unplug the power cord to ensure the power to the pump is off.
6. Remove the tube housing cover and flip to use as a tool in the
7. Align the center of the inverted cover with the center of the roller
Cover Feet
8. Hold the pump securely. Use the cover as a wrench and quickly
9. Apply a small amount of AquaShield
10. Place the tube housing cover (feet first) on the tube housing, affix the
Cover Bushing
continued
disconnected.
S30
- Place the new tube in the pump head and use your fingers to
center it on the rollers. H
S40
- Place the new tube in the pump head.
The square ends
help prevent the
tube from twisting
during operation.
- Use your fingers to center the tube on
front of the latches to the cover lip and then press the latches back
to secure. Be sure the cover is seated with the sleeve bearing on the
shaft and is flush with the housing before latching. I
button to allow the pump to run the roller assembly in its
collapsed position for four minutes. J
next step.
assembly so that the three holes on the face of the cover align with
the three knurled lugs on the roller assembly. Position the cover
feet near the bottom. K
NOTE: The roller assembly needs to be expanded so the tube is
pressed against the tube housing wall.
(snap) rotate the roller assembly clockwise to expand the roller
assembly. The tube will be pressed against the tube housing wall. L
DO NOT lubricate the pump tube. M
front of the latches to the cover lip and then press the latches back to
secure. Be sure the cover is seated with the sleeve bearing on the
shaft and is flush with the housing before latching. I
93
IMPORTANT: DO NOT TWIST THE
TUBE during installation. To ensure it
doesn't twist, keep the tube positioned
so the printed description stays
aligned along the length of the tube.
the rollers.
™
to the cover bushing ONLY.