Stenner Pumps S Serie Manual De Instalación Y Mantenimiento página 42

CONTROL MODES MENU
HALL EFFECT
page 3 of 3
A process flow that exceeds the maximum programmed flow rate will lead to incorrect dosing. It is
recommended that the user set the high flow alarm. Alarms activate when settings are exceeded.
NAVIGATION
Moves up in a menu, toggles
between options, or increase a value
Holding the or button causes the numbers to change rapidly.
Continued from previous page
Hall Effect
- Program Settings
- Alarm Settings
- Go to Main Menu
Set low flow. The alarm
activates when the flow falls
Select "Yes" to stop the pump in the
event of a low flow alarm. Select "No" to
allow the pump to continue operating in
the event of a low flow alarm.
To Hall Effect menu
S Series FW 4.01.02 US and Canada 800.683.2378, International 904.641.1666 www.stenner.com
continued
Moves down in a menu, toggles
between options, or decreases a value
Alarm on Low Flow?
Yes
yes/no
Yes
Low Flow Alarm
_ _ 0.0 GPM
below the setting.
adjust
Stop Pump on L ALM?
yes/no
Alarm on High Flow?
No
Yes
yes/no
Yes
High Flow Alarm
100.0 GPM
adjust
Stop Pump on H ALM?
yes/no
To Hall Effect menu
Moves one step back in
a menu, when permitted
No Select "No" to not enable the
low flow alarm and skip to the
high flow Alarm Settings.
set
set
No
set
set
Select "Yes" to enable high flow alarm. Select
"No" to not enable the high flow alarm and
return to Hall Effect Control menu.
Set high flow. The alarm activates when
the flow rises above the setting.
set
Select "Yes" to stop the pump in the
event of a high flow alarm. Select "No" to
No
allow the pump to continue running in
set
the event of a high flow alarm.
42
Sets a value in a menu