Stenner Pumps S Serie Manual De Instalación Y Mantenimiento página 37

CONTROL MODES MENU
0-10VDC
page 3 of 3
NOTE: Signal alarms are non-latching and will clear automatically when the signal returns to specified operating range.
Alarms activate when settings are exceed.
NAVIGATION
Moves up in a menu, toggles
between options, or increase a value
Holding the or button causes the numbers to change rapidly.
Continued from previous page
0-10 VDC
- Program Settings
- Alarm Settings
- Go to Main Menu
alarm activates when the
signal falls below the setting.
Select "Yes" to stop the pump in the
event of a low signal alarm. Select "No"
to allow the pump to continue running
in the event of a low signal alarm.
To 0-10VDC menu
Select "No" to not enable the high signal alarm
and return to the 0-10VDC Control menu.
S Series FW 4.01.02 US and Canada 800.683.2378, International 904.641.1666 www.stenner.com
continued
Moves down in a menu, toggles
between options, or decreases a value
Alarm on Low Signal?
yes/no
Set low signal level. The
Low Signal Alarm
adjust
Stop Pump on L ALM?
yes/no
No Alarm on High Signal?
yes/no
High Signal Alarm
adjust
Stop Pump on H ALM?
yes/no
To 0-10VDC menu
Moves one step back in
a menu, when permitted
No Select "No" to not enable the low signal alarm
and skip to the high signal Alarm Settings.
Yes
set
Yes
_ 0.1 VDC
set
No
set
Yes
set
Yes Select "Yes" to enable a high signal alarm.
Set high signal level. The
alarm activates when the
10.0 VDC
signal rises above the setting.
set
Select "Yes" to stop the pump in the
event of a high signal alarm. Select "No"
No
to allow the pump to continue running
set
in the event of a high signal alarm.
37
Sets a value in a menu