Stenner Pumps S Serie Manual De Instalación Y Mantenimiento página 26

CONFIGURATION MENU
OUTPUT RELAYS
page 4 of 5
Continued from previous page
Outputs
- Program Relays
- Enable/Disable
- To Configure menu
Select Relay
Relay #1
adjust
Select Relay #1,2, or 3 to
program and press ENTER.
Program the individual
output relays (1, 2, and/or 3)
as desired. Example below
illustrates selecting Relay #1.
Select "ON" to enable the relay to
activate for the specific condition.
Select "OFF" to deactivate the relay
for the specific condition. "OFF" is
the default mode.
NOTE: All condition options are
shown. Not all conditions are
applicable to all control modes.
S Series FW 4.01.02 US and Canada 800.683.2378, International 904.641.1666 www.stenner.com
continued
Relay #1
Normally Open
set n.o./n.c.
Relay #1
Leak Detect
on/off
Any Control Mode
IN DEVELOPMENT
Relay #1
Flow Detect
on/off
Manual
4-20mA
Relay #1
0-10VDC
Repeat Pulse
Pulse
7-Day
on/off
PPM-Constant
Cycle Timer
Relay #X Relay #1
Run Leak Detect
on/off on/off
Any Control Mode
Relay #X Relay #1
Leak Detect Transfer
on/off on/off
Relay #X Relay #1
Tube Timer Leak Detect
on/off
on/off
Relay #X Relay #1
Low Signal Leak Detect
on/off on/off
4-20mA
or
0-10VDC
Relay #1
High Signal
on/off
Relay #1
Normally Closed
set n.o./n.c.
Off
Relay #1
Low Flow
set
on/off
Off
Relay #1
High Flow
set
on/off
Off
Relay #X Relay #1
Leak Detect Drive Fault
set
on/off
on/off
Off Off
Relay #1 Relay #X
Leak Detect Overrun
set
set
on/off on/off
Off Off
Relay #X Relay #1
set set
Standby Leak Detect
on/off on/off
Off Off
Relay #X Relay #1
set set
Off Leak Detect
on/off on/off
Off Off
Relay #1
set set
Mode Change Off
on/off
Off
To Outputs menu
set
26
set
Off
Hall Effect
set
Hall Effect
Off
or
PPM Feed–Variable
set
Off Off
Any Control Mode
set set
Off Off
Pulse
set set
Off Off
set set
Any Control Mode
Off Off
set set
On Continued on
set
next page
Off