Stenner Pumps S Serie Manual De Instalación Y Mantenimiento página 50

CONTROL MODES MENU
PPM FEED – VARIABLE FLOW, HALL EFFECT
A process flow that exceeds the maximum programmed flow rate will lead to incorrect dosing. It is
recommended to the high flow alarm. Alarms activate when settings are exceeded.
NAVIGATION
Moves up in a menu, toggles
between options, or increase a value
Holding the or button causes the numbers to change rapidly.
PPM Feed
- Constant, Flow Switch
- Variable, Hall Effect
- Go to Main Menu
PPM Feed
- Constant, Flow Switch
- Variable, Hall Effect
- Go to Main Menu
To Main Menu
After completing Program and Alarm
Settings, select
"Go To Main Menu" and press ENTER
to return to the Main Menu.
S Series FW 4.01.02 US and Canada 800.683.2378, International 904.641.1666 www.stenner.com
continued
Moves down in a menu, toggles
between options, or decreases a value
PPM Feed Variable Flow
- Program Settings
- Alarm Settings
- GO TO PPM FEED MENU
PPM Feed Variable Flow
- Program Settings
- Alarm Settings
- GO TO PPM FEED MENU
PPM Feed Variable Flow
- Program Settings
- Alarm Settings
- GO TO PPM FEED MENU
To PPM Feed Menu
50
page 5 of 6
Moves one step back in
a menu, when permitted
Continued on next page
Select "Yes" to enable high flow (process flow > 100%)
alarm. Select "No" to not enable the high flow alarm and
return to the PPM Variable Flow Control menu.
Alarm if speed>100%?
Yes
adjust
Yes
Delay to Activate
_ _ 0 second(s)
adjust
Stop Pump on H Alarm?
No
adjust
Go to PPM Variable Flow menu
Sets a value in a menu
No
Go to
PPM Variable
Flow menu
set
Set the delay until the
alarm is to be activated
after process flow
exceeds 100% (0 to
set
999 seconds).
Select "Yes" to stop the
pump in the event of a
high flow alarm. Select
"No" to allow the pump to
set
continue running in the
event of a high
flow alarm.