Stenner Pumps S Serie Manual De Instalación Y Mantenimiento página 65

OPERATING DISPLAY
DISPLAY ALARMS
(Control Mode)
Off
Can be
any
(Control Mode)
Control
Tube Leak
Mode
The
(selected
(Control Mode)
control
DRIVE FAULT
mode)
appears in
upper left
corner
(Control Mode)
TUBE CHANGE
(Control Mode)
Standby
PULSE
Pulse
OVERRUN
PPM Feed
PPM Feed–
High Flow
Variable
4-20mA
Low Signal
4-20mA
or
0-10VDC
0-10VDC
High Signal
Hall Effect
High Flow
Hall Effect
Hall Effect
Low Flow
S Series FW 4.01.02 US and Canada 800.683.2378, International 904.641.1666 www.stenner.com
continued
Return to Selected Control Mode
When ON/OFF is pressed
again, display returns to
selected control mode.
%
%
%
If password was not set.
SIGNAL
If password was set, ENTER
PASSWORD first.
Process
If password was entered
incorrectly, the display
shows INCORRECT
PASSWORD for 3 seconds
and then returns to the
mA
beginning of alarm.
VDC
Process
Process
Not all alarms apply to all modes.
Operating modes are displayed in the
upper left corner.
When a pump condition occurs, an active
display alarm appears and blinks 3 times
in succession.
The screen cycles between showing the
display alarms and showing the operating
screen until the alarms are reset.
Reset Alarm?
Yes
yes/no
Go to Main Menu
65
If yes, reset all alarms.
If no, do not reset alarms.
select