Stenner Pumps S Serie Manual De Instalación Y Mantenimiento página 29

CONFIGURATION MENU
RESET PUMP
Operator can reset the pump and return the pump to factory default settings.
NOTE: When resetting a pump with firmware version 2.01.04 or higher, the 4-20mA input signal calibration will be
restored to factory defaults.
NAVIGATION
Moves up in a menu, toggles
between options, or increase a value
Holding the or button causes the numbers to change rapidly.
Configuration
- Modbus Setup
- Firmware Version
- Reset Pump
Select "Yes" and press ENTER to
return the pump to factory
default settings. You will be asked
to confirm this action.
Select "No" and press ENTER to
return to Configuration menu
without resetting the pump.
S Series FW 4.01.02 US and Canada 800.683.2378, International 904.641.1666 www.stenner.com
continued
Moves down in a menu, toggles
between options, or decreases a value
Reset To Defaults?
Yes
yes/no
set
Reset To Defaults?
No
yes/no
set
To Configuration menu
29
Moves one step back in
a menu, when permitted
Are you sure?
Yes
yes/no
set
Are you sure?
No
yes/no
set
To Configuration menu
Sets a value in a menu
Reset pump to
factory default.
Go to
Main Menu
Select "Yes" to confirm
resetting the pump to factory
defaults and returning to the
Main Menu.
Select "No" to return to
Configuration menu without
resetting the pump.