Stenner Pumps S Serie Manual De Instalación Y Mantenimiento página 59

OPERATING DISPLAY
HALL EFFECT
NAVIGATION IN HALL EFFECT MODE
PRIME
Runs pump at 100% speed
while button is pressed
• If a password is set, the pump controls will lock out after 60 seconds if there is no keypad activity.
• To unlock the pump, press ENTER for 2 seconds. The pump will display a prompt to enter a password.
Run Pump?
Yes
yes/no
Hall Effect
OFF
If unlocked or password not set.
Bar graph along
bottom shows rate
of incoming pulses
from 0 to 100%
NOTE: Displayed outputs are approximate and may be rounded off. For some units
of measure, flows close to zero may display zero.
S Series FW 4.01.02 US and Canada 800.683.2378, International 904.641.1666 www.stenner.com
continued
ON/OFF
Turns pump control ON or OFF
WARNING: DOES NOT remove power.
Hall Effect
50.0
select
%
Hall Effect
100
Pump runs at 100% speed while
the PRIME button is pressed (if
unlocked or password not set).
BACK
Cycles the display through
the units of output,current
process flow, and total
process flow (gallons or
liters, GPM or LPM).
%
Enter password if display is locked.
To Main Menu if unlocked.
Hold for 2 seconds
%
Prime
Metric is displayed if selected
in Configuration
59
ENTER
Press and hold for 2 seconds
to go to the Main Menu
Hall Effect Process Gal
999,999.9
Hall Effect Process GPM
2.5
Hall Effect RPM
22
Hall Effect GPD
20.0
Hall Effect GPH
0.83
Hall Effect oz/min
1.77