marposs MIDA TOOL EYE Manual De Instalacion Y Uso página 75

5.3.4 Mounting the arm and the shear pin
WARNING
It is not necessary to remove the probe from the arm when performing this operation.
Use the wrenches supplied with the probe kit.
Partially tighten the grub screws that secure the arm to the shear pin so that it is free to rotate
under friction.
Perform the operations illustrated in Figure 5-6:
1
Figure 5-6. Mounting the arm and the shear pin
5.3.5 Adjusting the stylus
5.3.5.1 Approximate adjustment
Perform the operations illustrated in Figure 5-7:
Arrange the cube so that it is approximately parallel to the X and Z axes.
1
Figure 5-7.
2
2
3
Section 5. INSTALLATION
4
3
75