marposs MIDA TOOL EYE Manual De Instalacion Y Uso página 83

5.5.2 Delay and skip PROBE OUTPUT (JP5-JP6)
The P.O. (Probe Output) can be set to normal, delay or skip mode using jumpers JP5 and JP6 on circuit
board of Interface (see Figure 5-15).
Remove the four screws and open the case in order to access it and Install Jumpers as shown in the Figure 5-15.
Figure 5-14. Operating cycle diagram.
B
SKIP
Enabled
(*)
A
SKIP
Disabled
A
Delay
Enabled
(*)
B
Delay
Disabled
(*)
Note: Default condition
Figure 5-15. Probe Output: Normal, Skip and Delay modes.
Section 5. INSTALLATION 83