Publicidad
• CYLINDER HEAD WARPAGE
1) Remove the carbon deposits from the combustion
chamber. Clean off any gasket material from the cylinder
1
head surface.
2
2) Check the spark plug holes and valve seats for cracks.
3) Check the cylinder head for warpage using a straight edge
3
and a feeler gauge.
4
Standard
Less than 0.05 mm
5
(0.002 in)
6
4) If the measurement exceeds the service limit, recondition
the cylinder head.
7
Cylinder head reconditioning procedure:
Apply Prussian Blue compound to the level block to identify
8
the warpage, and using a fine oil stone, grind the cylinder
head in a "figure 8", with the warped part being the center
9
of the ground part. Or use the lapping machine to
recondition the cylinder head.
10
11
12
13
14
15
16
17
18
19
20
9-18
[1]
MEASUREMENT POINT:
Service limit
0.10 mm
(0.004 in)
122
Publicidad
Capítulos
