Pressure Gauge - Honda BF40D Manual De Instrucciones

5) Connect the battery cables to the power tilt motor
2P connector terminals to compress the piston rod fully
once. (Perform <To compress the piston rod> on P. 14-33.)
1
6) Connect the battery cables to the power tilt motor
2
2P connector terminals to extend the piston rod fully again.
(Perform <To extend the piston rod> on P. 14-33.)
Read the pressure gauge to measure the lower chamber
3
side hydraulic pressure with the piston rod extended fully.
4
Lower chamber
hydraulic pressure 2,802 - 3,342 psi)
5
• If the measurement is outside the specification, check the
power trim/tilt assembly for oil leakage.
6
• If the oil is not leaking but the hydraulic pressure dropped
sharp below the specification, oil can be leaking through
7
the oil seal inside the power tilt motor assembly.
Disassemble the power tilt motor assembly (P. 14-46) and
8
check it, then measure the lower chamber hydraulic
pressure again (P. 14-36).
9
7) Measure the upper chamber hydraulic pressure as follows.
10
11
12
• UPPER CHAMBER SIDE HYDRAULIC PRESSURE
INSPECTION
13
1) After measuring the lower chamber hydraulic pressure,
remove the special tool (gauge joint B) with the piston rod
extended fully and replace it with the special tool (gauge
14
joint A).
Tighten the special tool (gauge joint A) to the specified
15
torque.
16 TORQUE: 1.7 N . m (0.2 kgf . m, 1.3 lbf . ft)
TOOLS:
17
Gauge joint A (Upper chamber)
Gauge joint B (Lower chamber)
18
• The ATF will spout out when the special tool (gauge joint
19
B) is removed unless the piston rod is extended fully. Be
sure to extend the piston rod fully before removing the
special tool (gauge joint B).
20
• A small quantity of ATF will flow out when the special
tool (gauge joint B) is removed. Install the special tool
(gauge joint A) quickly.
• Take care not to move the seal washer out of position or
collapse it inside the cylinder comp.
2) Install a commercially available pressure gauge to the
special tool (gauge joint A).
3) Check the ATF level with the piston rod extended fully
(P. 14-34).
It must be at the edge of the oil filler port.
14-37
19.3 - 23.0 MPa (197 - 235 kgf/cm
070PJ-V150100
070PJ-V150200
[1]
Extend the piston
rod fully.
2
,
[1]
SEAL WASHER
[4] Install.
[5]
GAUGE JOINT A
(UPPER CHAMBER)
070PJ-V150100
492
[2]
GAUGE JOINT B
(LOWER CHAMBER)
070PJ-V150200
[3] Remove.
[6]

PRESSURE GAUGE

(Commercially available)