Publicidad
6) Install a commercially available universal bearing puller
between the reverse bevel gear and bearing.
1
• Be sure that the universal bearing puller is set on the
bearing outer race securely.
2
7) Set a wood block or equivalent material on the
commercially available universal bearing puller as shown.
3
Drive the reverse bevel gear/bearing assembly into the
propeller shaft holder using the hydraulic press.
4
• If the reverse bevel gear is protruding from the top
5
surface of the universal bearing puller and the wood
block is in contact with the reverse bevel gear, set a
spacer between the wood block and the universal bearing
6
puller to drive the reverse bevel gear/bearing assembly.
7
8
9
10
11
12
8) Set a wood block under the reverse bevel gear.
13
9) Apply soapy water to the outer surface of the 22 x 35 x 7
14
mm water seals.
15
10) Drive the 22 x 35 x 7 mm water seals one by one into the
propeller shaft holder using the special tools. Note the
16
installation direction of the water seals.
Apply marine grease to the water seal mating surfaces
before installation.
17
TOOLS:
18
Driver
Attachment, 32 x 35 mm
19
Pilot, 22 mm
11) After installation of the water seals, apply marine grease to
20
the water seal lips.
11-15
[1]
UNIVERSAL
BEARING PULLER
(Commercially
available)
[5]
REVERE BEVEL GEAR/
BEARING ASSEMBLY
[2] <WATER SEAL INSTALLATION DIRECTION>
[1]
22 x 35 x 7 mm
WATER SEALS
[4]
DRIVER
07749-0010000
07749-0010000
07746-0010100
07746-0041000
[8]
REVERSE
BEVEL GEAR
[7]
WOOD
BLOCK
250
[2]
Wood block must not
be in contact with the
reverse bevel gear.
[3]
WOOD BLOCK
[4]
PROPELLER SHAFT
[3]
(Apply marine grease to the water
seal mating surfaces and the lips.)
[5]
ATTACHMENT,
32 x 35 mm
07746-0010100
[6]
PILOT, 22 mm
07746-0041000
Publicidad
Capítulos
