Gear Case Assembly/Extension Separator [Semi-Long/Extra-Long Shaft Types Only] - Honda BF40D Manual De Instrucciones

2. GEAR CASE ASSEMBLY/
EXTENSION SEPARATOR
1
[SEMI-LONG/EXTRA-LONG SHAFT
2
TYPES ONLY]
3
a. REMOVAL
1) Remove the propeller (P. 11-2).
4
2) Move the shift to the "N" (Neutral) position.
3) Tilt the outboard motor up to the uppermost position. Pull
5
the tilt stopper down to secure the outboard motor.
4) Loosen the shift rod B lock nut and disconnect the shift rod
6 A and the shift rod B by turning the shift rod joint nut.
5) Remove the 8 x 20 mm hex bolt and 8 mm washer, and
7
remove the trim tab from the gear case assembly.
8
9
10
11
12
6) Remove the four 10 x 40 mm hex bolts, four 10 mm
13
washers, 8 x 65 mm hex bolt and the 8 mm washer, and
remove the gear case assembly from the outboard motor
14
[Short/long shaft types only].
15
Remove the four 10 mm self-locking nut, four 10 mm
washers, 8 mm self-locking nut and the 8 mm washer, and
16 remove the gear case assembly and extension separator
from the outboard motor [Semi-long/extra-long shaft types
only] (P. 11-4).
17
Remove the two 6 x 10 mm dowel pins.
18
19
20
11-3
[1]
SHIFT ROD
JOINT NUT
[3]
SHIFT ROD B
[3]
8 mm WASHER
[1]
6 x 10 mm
DOWEL PIN (2)
[6]
10 mm
WASHER (4)
[5]
10 x 40 mm HEX
BOLT (4)
226
[2]
LOCK NUT
[1]
TRIM TAB
[2]
8 x 20 mm
HEX BOLT
[2]
GEAR CASE
ASSEMBLY
[3]
8 mm
WASHER
[4]
8 x 65 mm HEX BOLT