Honda BF40D Manual De Instrucciones página 72

11) Tighten the 10 x 32 mm flange bolt to the specified torque
using the special tool as shown.
1
TOOL:
56 mm lock nut wrench
2
TORQUE: 57 N . m (5.8 kgf . m, 42 lbf . ft)
3
4
5
6
7
8
12) Check that the "T " mark on the pulser rotor is in alignment
9
with the "T " mark on the cylinder head.
If the marks are out of alignment, set the special tool on the
pulser rotor and turn the pulser rotor counterclockwise to
10
align the marks.
11
TOOL:
56 mm lock nut wrench
12
13
14
15
16
17
13) Check that the " T" mark on the alternator rotor is in
alignment with the "
18
If the marks are out of alignment, turn the alternator rotor
counterclockwise to align the marks.
19
NOTICE
20
Be sure to turn the alternator rotor in the direction shown
with the arrow. Do not turn in the opposite direction.
7-28
07LPA-ZV30200
07LPA-ZV30200
" mark on the cylinder block.
[1]
56 mm LOCK NUT
WRENCH
07LPA-ZV30200
[2]
"T " MARK
[1]
" T" MARK
[2]
" " MARK
72
[1]
"T " MARK