Craftsman 27710 Manual De Las Instrucciones página 23

2
_To install bagger components to tractor
1. Discharge Chute
2. 3/8 Nut
3. Flat Washer
3
1. SupportBracket
2. 318CarriageBolt
3. 3/8 LockNut 1
5
4. 3/8 x 63,5mm Hex Bolt
5. 10,3mm (13/32") flat
washer
2
Remove discharge chute from rear of tractor. Unhook the
two (2) straps and pull chute out and away from tractor.
Remove the two (2) 3/8 nuts and fiat washers from the
bolts at the tractor back plate,
1. 3/8 Lock nut
2. Flat Washer
3. Support Tube
Using the nuts and flat washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
Install the two upper support brackets through the back
plate and to the chassis, usingthe 10 x 19 mm (3/8"x3/4")
carriage bolts and Iocknuts supplied. Tighten securely.
Assemble both support brackets to the outside of the
baggger support tuba using two each 3/8 x 63,5mm hex
bolts13/32 I.D. fiat washers and 3/8 lecknuts from parts
bag. Tighten securely.
1. Hook
2. Discharge Chute _
3. Back plate slot
3
• Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the discharge chute to float with the
mower deck when moving on uneven terrain.
23