Assigning A Unit Number - Blackmagic Design Ultimatte 12 Manual De Operaciones

Ocultar thumbs Ver también para Ultimatte 12:

Idiomas disponibles

Ethernet port on the rear panel of Ultimatte 12 8K

Connecting Directly

Connecting via a Network

Your Ultimatte unit has a default static IP address of 192.168.10.220. All Ultimatte models

except Ultimatte 12 support DHCP so the unit can be found on your network automatically and

assigned an IP address. For information on how to manually set the network settings, refer to

the 'connecting to a network' section.

Assigning a Unit Number

Once you have connected to a computer or Ethernet switch, launch Ultimatte Software Control.

The software will automatically look for connected Ultimatte units.

When launching Ultimatte Software Control for the first time, a window will appear asking for

you to assign your Ultimatte unit to a number. This is because up to 8 Ultimatte units can be

controlled, therefore the software needs to identify each one. This only needs to happen the

first time you connect to Ultimatte Software Control. Once the unit is assigned a number, it will

be remembered the next time you launch the software.

Ultimatte 12 4K

Ultimatte Software Control