Descargar Imprimir esta página

Setting Up A Gpi Event List - Blackmagic Design Ultimatte 12 Manual De Operaciones

Ocultar thumbs Ver también para Ultimatte 12:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 411
Remove All
This button will remove all the files from the selected GPI events list.
Step
Click this button to move down through the highlighted file selection and automatically load the
selected file into the current work space. Any file on the GPI events list can be highlighted and
loaded in the current work space by touching the corresponding file name.
Reset
Clicking this button will select the top file from the GPI files list without loading the first file.
The first file will be loaded when the first GPI pulse is detected.
GPI Input Enable
This checkbox enables or disables individual GPI inputs separately based on the setting of the
GPI input select control.
GPI High Enable
Enables the software to detect either low to high or high to low transitions of the GPI inputs.
The GPI inputs are triggered by the logic level of the input signal, not by the transition edges.
If GPI high enable is checked, the selected input will be triggered by a high logic state. If GPI
high is not checked, the selected input will be triggered by a low logic state.
GPI IN Delay
This is a delay between detecting a GPI input and that of actual execution of the GPI list.
The GPI input delay can be set at different values for each input. The maximum delay is
120 Frames.
Close
Selecting this button will close the window and exit the GPI setup menu.

Setting Up a GPI Event List

To set up an event list, preset files must be previously created and saved. Refer to the 'saving
and managing presets' section for more information.
1
Click on the 'settings' menu button and select 'GPIO' in the groups section. Click the
'GPIO setup' button and the GPIO setup window will be displayed.
2
From the tabs, select a GPI number from 1 to 5 to be used. If the selected GPI number
was used before, the event list will show the previously selected files. The existing
event list can be edited by removing, adding or inserting files. Alternately, select
'remove all' to remove all the files from the event list.
3
Select the file to be added to the event list. When selected, the file will be highlighted.
4
Click on the 'add' button to add the file to the event list.
5
To add more files to the event list, repeat steps 3 and 4.
When the event list is complete, click 'reset' to move to the beginning of the event list. Adjust
GPI input delay if necessary. This is the delay, in frames, when loading the files from the time
the GPI pulse is received.
1
For high GPI input logic state, select the 'GPI high enable' checkbox. Leave deselected
if using a low logic state.
2
Enable GPI by selecting the GPI input enable checkbox.
3
Repeat these steps for each GPI input.
Settings
58

Publicidad

loading