Using Smart Remote 4
If you are using an optional Smart Remote 4 to control your Ultimatte, you will first need to install
the latest version of Ultimatte Software Control. For more information, refer to the 'updating
your Smart Remote 4' section.
Connecting Power
Plug the included power adapter into the DC power input on the rear panel. The screw ring is
used to secure the connector to the port.
TIP
The power adapter's outside screw ring also serves as the negative contact,
with the positive contact being the center pin of the connector. If you want to secure
a ground connection to the chassis of your Smart Remote 4, you can attach it to the
terminal lug located next to the power input.
Connecting to Ultimatte
Connect an Ethernet cable from the rear panel of your Ultimatte to the left side Ethernet port of
Smart Remote 4.
Plug your Ultimatte main unit into the Smart Remote 4's left side Ethernet port
Using Smart Remote 4
74