Updating The Internal Software - Blackmagic Design Ultimatte 12 Manual De Operaciones

Reset
Reset your Ultimatte by clicking the 'factory reset' button. This will return your Ultimatte to its
original factory settings, any stills saved in the media pool will be deleted.

Updating the Internal Software

The setup utility lets you update your Ultimatte's internal software in addition to configuring the
network settings.
To update the internal software:
1 Download the newest Blackmagic Ultimatte Setup installer from
www.blackmagicdesign.com/support.
2 Run the Blackmagic Ultimatte Setup installer on your computer and follow the onscreen
instructions.
3 After installation is complete, connect your Ultimatte to your computer via USB
or Ethernet.
4 Launch Blackmagic Ultimatte Setup and follow any onscreen prompt to update the
internal software. If no prompt appears, the internal software is up to date and there is
nothing further you need to do.
Download the latest setup utility for your Blackmagic Ultimatte from the
Blackmagic Design support center at www.blackmagicdesign.com/support
Blackmagic Ultimatte Setup 73