Riester RVS-100 Manual Del Usuario página 74

B.7 Temp
Temp setup
Unit
Appendix C: Guidance and Manufacturer's Declaration of EMC
The monitor is intended for use in the electromagnetic environment specified below. The customer or the user of the monitor
should assure that it is used in such and environment.
Emission test
RF emissions
CISPR 11
RF emission
CISPR 11
Harmonic emissions
IEC 61000-­3-­2
Voltage fluctuations/ flicker
emissions
IEC 61000-­3-­3
The monitor is intended for use in the electromagnetic environment specified below. The customer or the user of the monitor
should assure that it is used in such an environment.
Immunity test
Electrostatic discharge
(ESD)
IEC 61000-­4-­2
Electrical fast
transient/burst
IEC 61000-­4-­4
Surge
IEC 61000-­4-­5
Voltage dips, short
interruptions and voltage
variations on power
supply input lines
IEC 61000-­4-­11
74
Factory defaults
℃
Guidance and manufacturer's declaration – electromagnetic emissions
-­for all EQUIPMENT and SYSTEMS
Guidance and manufacture's declaration – electromagnetic emission
Compliance
The monitor uses RF energy only for its internal function.
Group 1 Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.
The monitor is suitable for use in all establishments other than
Class A
domestic and those directly connected to the public low-­voltage
power supply network that supplies building used for domestic
purposes.
Class A
Complies
Guidance and manufacture's declaration – electromagnetic immunity
IEC 60601 test level Compliance level
±6 kV contact ±6 kV contact
±8 kV air ±8 kV air
±2 kV for power supply lines ± 2kV for power supply
lines
±1 kV for input/output lines
±1 kV differential mode ±1 kV differential mode
±2 kV common mode ±2 kV common mode
<5% UT <5% UT
(>95% dip in UT) (>95% dip in UT)
for 0.5 cycle for 0.5 cycle
40% UT 40% UT
(60% dip in UT) (60% dip in UT)
Electromagnetic environment – guidance
Electromagnetic environment -­
guidance
Floors should be wooden, concrete or
ceramic tile. If the floor is covered with
synthetic material, the relative humidity
should be at least 30%.
Users must eliminate static in their
hands before use.
Mains power quality should be that of
a typical commercial or hospital
environment.
Mains power quality should be that of
a typical commercial or hospital
environment.
Mains power quality should be that of
a typical commercial or hospital
environment. If the user of the monitor
requires continued operation during
power mains interruptions, it is
recommended that the monitor be
powered from an uninterruptible power
supply or a battery.
33