VM Motori R753IE5 Manual Instrucciones Para El Uso página 81

SAFETY WARNINGS FOR THE ELECTRICAL EQUIPMENT
The electrical equipment was designed
and manufactured according to the
GB
provisions of the standards in force on the
matter.
IMPORTANT
- Do not use quick starters to start the
engine.
- Do not disconnect the electrical
power supply when the engine is
running.
RESIDUAL RISKS
During the engine design and manufacture
phases, the manufacturer paid special
attention to the aspects which may cause
any risk for the safety and health of people
interacting with the engine.
Despite this, some potential and hidden
risks still exist.
English
IMPORTANT
Before disconnecting power supply,
remove the ignition key and wait at
least 6 minutes before disconnecting
the negative battery cable.
– Before performing arc welding on the
frame where the engine is installed,
ALWAYS disassemble the electronic
control unit and protect all electrically
connected devices that are installed
close to the negative pole (ground).
DANGER - WARNING
- Danger of injury to upper limbs: Do
not put your hands inside any moving
part.
- Danger of burning/scalding:
Pay attention to hot surfaces and
radiated heat.
- Electrocution hazard:
Do not come into contact with electrical
components, electrical wiring and
other engine parts without having
disconnected the engine ignition key
and waited at least 6 minutes before
disconnecting the negative battery
cable.
18
R753IE5
42432107F