Schulz Control I Manual De Instrucciones página 232

9.3 EVENT LIST
Each stored event (P04.01.01 - P04.01.200) includes an index, event description, and time and date that the event occurred. Examples:
• Pressed start button
• Pressed stop button
• Dryer On
• Admin user enabled
• Modified parameter
9.4 PARAMETERS FOR SETTING UP START AND/OR LOAD SOURCE
Parameters (notes):
• Discharge pressure sensor (standard)
• Digital input (requires setting an available digital input)
• Serial port with Airbus485™ protocol
• Serial port with MODBUS protocol
• Ethernet communication port TCP/IP (requires ethernet communication port, optional for some product models)
• Modified parameter
9.5 USING MENUS AND PARAMETERS
Users of the Control NET electronic interface should notice that the menus are arranged sequentially from P00 to P99. However, some menus are
intentionally omitted. This can happen for many reasons and is perfectly normal.
Numbers of the menus and their names are shown below:
Number Menu name
P00 Start
P01 Hour Meters
P02 Usage
P03 Error list
P04 Event list
P05 Service provider
P06 Interface Data
P07 Compressor data
P08 Message codes
P09 Access
9.6 EQUIPMENT CONDITIONS OR STATUS CODES
Number State
Stopped equipment
01 The stopped equipment status always occurs after an immediate stop condition. This status can only be removed from the interface when
the immediate stop condition that originated it is solved.
Powering up
02
Control NET Interface boot
Start impediment
03 A start impediment is usually associated with a start impediment condition, such as an impediment related to open cabinet door, low
temperature or elevated internal pressure.
04 Ready to start
Cooling
When set, a cooling status precedes the start of the compressor. Cooling time is a period used to ensure that the compressor internal
05
pressure has reached a value low enough to enable the compressor to start safely.
Note: Factory-set cooling time ensures that the compressor is started safely. This value should not be changed by the user.
Standby
Other conditions may prevent the compressor from starting. When this condition is active the interface announces that the equipment is
waiting for the condition that prevents the start of the compressor to be solved.
06
These conditions may occur during normal equipment operation. For example, if the start button is pressed at the time the compressor
discharge pressure is greater than the set load pressure, the compressor will remain in standby until the discharge pressure is lower than
the load pressure.
Table 9.5 - Menus and Parameters
Number Menu name
P10 Equipment 1 settings
P11 Equipment 2 settings
P12 Equipment 3 settings
P13 FLEX Settings
P14 Motor protection
P15 Impediments
P16 Warning alarms
P17 Immediate stop alarms
P18 Input and output settings
P19 Sensor settings
Table 9.6 - Equipment Conditions or Status Codes
232
Number Menu name
P20 Diagnosis
P21 Run scheduling
P30 Table of compressors
P40 User 1 settings
P60 LED Settings
P80 GCI main menu (manager)
P81 GCI Settings (Manager)
P82 GCI Priority (Manager)