Schulz Control I Manual De Instrucciones página 233

Main motor starting sequence
07 The start of the main motor is commonly associated with the start time of the main motor that precedes any equipment load status. For
example: in a constant speed compressor, this is the star/delta start time added to the equipment load delay time.
Relief operation, load delay time
08
When set, the load delay time precedes the first time the compressor goes into load, after the main motor starts (see P11.02).
09 On-load operation
Funcionamento em alívio, tempo de recarga
10
Quando configurado, o tempo de recarga precede o retorno do funcionamento em carga do equipamento (veja: P11.03)
Relief operation, reload time
11
Operation in relief condition is usually associated with managing the number of main motor starts per hour.
Relief operation, stoppage time
Relief operation in stoppage time condition is usually associated with a main motor stoppage and the return of the equipment to ready-to-
12 -start condition. The stoppage time value must be enough for
the compressor to perform all of its mechanical stoppage functions that must be performed before the main motor stops. After this period,
the equipment will return to ready to start status (see: P11.05).
10. LIST OF ABBREVIATIONS
Abbreviation Text
ACTIVE Active or enabled
ADCT Compressor unit discharge temperature
ADV Automatic purge valve
AI Analog input
AIR Air
ALM Alarm or alarm message
AMB Environment
ANAL Analog
AO Analog output
APR April
AUG August
AUTO Automatic
AVAIL Available
BRG Bearing (s)
BELT Belt
BIN Binary
BUVV Butterfly valve
CAB Cabinet
CBV Bypass valve
CFG Settings
CLK Clock
CLR Heat exchanger
CNDS Condensed
COOL Cooling
COMP Compressor
COMMS Communication
COP Change Point
CO BK Continuous brake
CO Compressor output
CONFIG Setup or settings
CONT Contactor
CORR Correction
CT Current Sensor
CURR Current
CW Cooling water
CWT Cooling water temperature
DAY Day
Abbreviation Text
MANUF Manufacturer
MAR March
MAX Maximum
MAY May
MDL Model
META Manager
MIN Minimal
MIN'S Minutes
MMT Measurement
MON Monday
MOD Modulation
MOTOR Motor
MOPS Motor overload protection switch
MPA Mega Pascal
MPV Minimum pressure valve
MTH Month (s)
NC Normally closed
NO Normally open
NOM Rated
NUM Number
OCT October
OIL Oil
OK Safe or normal
OVLD Overload
OPT Optimal
OR Operating Range
OP CRT Open circuit
OS Oil separator
OSD On screen
OUT Output
P# Parameter 0, 1, 2, ...
PARA Parameter
PD Equipment discharge
PERMS Allowed
PLC Preprogrammed logic controller
PR Pressure
PRESS Pressure
233