Using The Media Page - Blackmagic Design ATEM Mini Manual De Instalación Y Funcionamiento

3 Now, click on the EQ indicators below input level controls and make equalization
changes to each input. You can move the windows into a better position, or close them
if needed.
4 After setting EQ, open the dynamics controls for each input by clicking on their
respective dynamics indicator. Make the required dynamics changes to generally
improve and refine the input audio.
5 With EQ and dynamics set for each input, you can now open the EQ controls for the
master output and sweeten the final audio mix.
6 Now open the master output's dynamics controls and make any required changes to
improve the final output.
Once all the Fairlight controls are set, you can then increase or decrease the faders on the
audio mixer to set them at their best levels for the live mix and make adjustments where
necessary during the production. You can also go back to any of the settings and make further
adjustments if needed, but it's best to follow the same order as described above to get the best
results from each function. For example, it's important to set EQ controls before making
dynamics changes as the processing chain in your switcher applies dynamics to the audio
after equalization.
Most important of all is to apply the effects carefully so your audio still sounds natural but
exciting too!

Using the Media Page

The media page is where all your graphics or stills are stored and is very easy to use.
Simply find the still you want to use with the browse window, then drag and drop the file into
a slot in the media pool. From there, you can load any one of those stills into the media player
and switch it to air using the media player 1 source button on the software control panel.
You can also use stills in the media player with the upstream and downstream keyer.
Keep reading this section for information on how to use the media page in
ATEM Software Control.
Using ATEM Software Control 33