Controlling Hyperdecks With Atem Software Control - Blackmagic Design ATEM Mini Manual De Instalación Y Funcionamiento

Controlling HyperDecks with ATEM Software Control

To control the HyperDecks connected to your switcher, click the 'media player' tab in the
software control panel, and choose the 'HyperDecks' palette.
Here you can choose between each of the HyperDecks connected to your system by clicking
one of the four buttons along the top of the panel. These are named according to the labels
entered in ATEM settings. Available HyperDecks are shown with white text, while the
HyperDeck you are currently controlling is shown in orange.
Choose from up to four HyperDecks by clicking
their selection buttons in the HyperDecks palette
In addition to the text color, each HyperDeck's selection button also has a tally indicator.
Green Outline
Indicates a HyperDeck that is currently switched to the preview output.
Red Outline Indicates a HyperDeck that is currently switched to the program output,
meaning it is currently live to air.
You may also see one of the following status indicators above the selection
buttons for your HyperDecks.
Ready HyperDeck is set to remote and a disk is inserted. It is ready for playback and
recording if space is available.
Record
HyperDeck is currently recording.
No Disk
HyperDeck has no disk inserted.
Local HyperDeck is not set to 'remote' and cannot currently be controlled by your
ATEM switcher.
When you select a HyperDeck, you'll see information about the currently selected clip such as
the name and length, as well as time elapsed and time remaining. Below this you'll see the
control buttons.
HyperDeck Control 86