Recording Macros Using Atem 1 M/E Advanced Panel - Blackmagic Design ATEM Mini Manual De Instalación Y Funcionamiento

Graphic wipe screen width requirements
If the switcher is operating at 1080p then the graphic should be no wider than
1080p
1,920 pixels.
If the switcher is operating at 1080i then the graphic should be no wider than
1080i
480 pixels.
If the switcher is operating at 720p than the graphic should be no wider than
720p
320 pixels.
Manual Transitions
Manual transitions let you manually transition between program and preview sources using the
fader bar in the transition control block. Mix, dip, wipe and DVE transitions can all be performed
as a manual transition.
To perform a manual transition
1 On the preview bus, select the video source that you want on the program output.
2 Select the transition type using the transition type buttons in the transition
control block.
3 Manually move the fader bar from one end to the other to execute the transition.
The next move on the fader bar will begin a new transition.
4 During the transition the red and green buttons on the program and preview buses
both turn red to indicate that you are in the middle of a transition. The LED indicator on
the fader bar also displays the position and progress of the transition.
TIP You will also see ATEM Software Control mirror the move on the
software panel.
5 At the end of the transition, sources selected on the program and preview buses are
exchanged to indicate that the video source that was on preview is now on program
and vice versa.

Recording Macros using ATEM 1 M/E Advanced Panel

You can record and run macros using an ATEM 1 M/E Advanced Panel independently of
ATEM Software Control. All actions on the ATEM Software Control switcher page can be
performed using your hardware panel. If you need to arrange graphics in the media pool, or
adjust camera settings, simply access those settings using ATEM Software Control.
The buttons used to record and run macros on the ATEM 1 M/E Advanced Panel are located in
the system control buttons. The names of your macro buttons are displayed in the source select
names display.
Follow the steps below to create the 'transitions' macro demonstrated earlier using
ATEM Software Control. This time you will create a macro in macro slot 2.
1 Press the 'macro' soft button to open the macros LCD menu.
2 Using the 'macro' knob under the LCD, select the macro slot you want to record to.
For this example, select slot 2.
Using External ATEM Hardware Panels 81