Changing The Hardware Panel Network Settings - Blackmagic Design ATEM Mini Manual De Instalación Y Funcionamiento

Ocultar thumbs Ver también para ATEM Mini:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 447
NOTE
Changing the switcher IP address on your panel does not change the
IP address of ATEM Mini itself. It just changes where the control panel is looking to find
the switcher.
Setting DHCP or Fixed IP Addresses
External ATEM hardware control panels can be set to DHCP or fixed IP addresses. Generally
when used on a network, the control panel should be selected to DHCP, which means it is
automatically assigned an IP address when connected to the network.
NOTE
ATEM Mini always needs a fixed IP address so the external control panel has a
stable IP location to connect to.

Changing the Hardware Panel Network Settings

Because the hardware panel is also on the network and communicating with the switcher,
it also has network settings so it can connect to the network. These settings are different to the
switcher IP address, which is just where the panel is looking to find the switcher. The panel
network settings can be changed by following the steps below:
Changing Network Settings on ATEM 1 M/E Advanced Panel
Change network settings using the system
control buttons and LCD soft controls
1
Press the 'home' button in the system control buttons to open the LCD home menu.
2
In the home menu, press the 'network' soft button to open the network settings.
3
The next step is to decide if you want the panel to use a fixed IP address or to be
automatically assigned an IP address from a DHCP server. Set DHCP on or off by
pressing the corresponding DHCP ON/OFF soft button.
Connecting to a Network
62

Publicidad

Tabla de contenido
loading

Tabla de contenido