Performing Transitions Using Atem 1 M/E Advanced Panel - Blackmagic Design ATEM Mini Manual De Instalación Y Funcionamiento

Joystick Control
Button Mapping
ATEM software and hardware control panels support button mapping so you can assign your
most important sources, especially cameras, to the most accessible buttons in the program and
preview rows. Occasional sources can be assigned to less prominent buttons. Button mapping
is set independently for each control panel so button mapping set on a software control panel
will not affect the button mapping set on a hardware control panel.
ATEM Advanced Panel Button Mapping and Button Brightness Level
To access the button mapping settings, press the 'settings' button to open the general switcher
settings LCD menu, then press the 'button mapping' soft button.
Use the control knobs under each LCD setting to select the button you want to map and the
input you want to change it to. You can also change the button color and label color that is
displayed on the panel if you want to highlight specific sources. For example, you may want to
highlight your playback sources a different color so you can instantly identify them on the panel.
The button will illuminate on both the preview and program rows until the source is switched to
the preview or program output, where it will change to green or red respectively.
Once you have changed the setting, the change is made instantly and you don't have to worry
about saving. Simply press the 'home' button to return to the home menu.
If you want to change the brightness of the buttons, press the 'settings' button to open the
general switcher settings LCD menu, then press the 'panel' soft button to reveal the
panel settings.
Rotate the settings knob under each setting until you see the desired brightness level.
Once you have configured all the button settings, press the 'home' button to return to the
home menu.

Performing Transitions using ATEM 1 M/E Advanced Panel

ATEM 1 M/E Advanced Panel shares the same control panel layout as the software control
panel, plus a large LCD with soft control knobs and buttons which lets you adjust settings
dynamically as you control your switcher. This is a fast and convenient way of working with
your panel.
This section describes how to perform the various transition types on your switcher using an
external ATEM 1 M/E Advanced Panel.
Using External ATEM Hardware Panels 71