Atem Software Control Via The Network - Blackmagic Design ATEM Mini Manual De Instalación Y Funcionamiento

NOTE If you're connecting direct to a switcher without a network, then you
won't have a DHCP server to assign an IP address automatically, so you will
want to select 'DHCP off'. ATEM 1 M/E Advanced Panel is delivered with a
fixed IP address set to 192.168.10.60 for a direct connection.
However, if your network has lots of computers that automatically assign
IP addresses via DHCP, then you can also select 'DHCP on' so the panel can
get its network information automatically. This is possible on the panel, and it's
only the switcher itself that always requires a fixed IP, as the switcher needs to
be found by the control panels at a known fixed address on your network.
If you select 'DHCP on', your network settings will be complete because the
panel network settings will be obtained from the network automatically.
4 If you have elected to use a fixed IP address, you now need to set this IP address by
adjusting the corresponding soft control knobs for each field of the IP address.
You can also use the numeric keypad. Changing this IP address may cause the panel
to lose communication.
5 If the subnet mask and gateway address need to be set, then press the right arrow
button in the system control buttons to progress through each setting menu, and use
the knobs or the numeric keypad to edit. If at any time you want to cancel the changes,
press 'undo'.
6 When you are happy with your settings, press the 'save changes' soft button to confirm.
When you are happy with your network settings,
press the 'save changes' button to confirm them

ATEM Software Control via the Network

Lastly, if you want to use ATEM Software Control as well as an external ATEM hardware panel,
you need to ensure your computer is connected and working on your network. Once launched,
if ATEM Software Control cannot communicate with ATEM Mini, you will be prompted
automatically to enter ATEM Mini's IP address. Once you have set the address, ATEM Software
Control can find your switcher and communicate.
Connecting to a Network 63